topp
Innebörden av parallell inverter
Innebörden av parallell inverter

Den parallella växelriktaren består av två tyristorer (T1 och T2), en kondensator, centrumuttagstransformator och en induktor. The thyristor is used to provide a current path, while the inductor L is used to make the current source constant. These thyristors are controlled on and off by commutation capacitors connected between them.
This complementary commutation method is used to turn the capacitor on and off. Complementary commutation means that when T1 is on, the firing angle is applied to T2 and then the capacitor will turn off T1. What exactly happens is that when T2 is on and the firing angle is applied to T1, T2 will be off due to the capacitor voltage. The output current and voltage are Io and Vo respectively.

It is called a parallel inverter because in the working state, the capacitor C is connected in parallel with the load through the transformer. A shunt inverter is also called a center-tapped transformer inverter because it has a center-tapped transformer between the load and the drive circuit. The function of a transformer is to convert DC into alternating current of the required voltage.

Working of parallel inverters
It operates in simple two modes.
Läge 1
When T1 is triggered, the commutation capacitor will close T2 and the current in the primary winding will flow from A to n. This current in the primary winding will cause the current in the secondary winding to flow clockwise.
Läge 2
By triggering T2, the commutation capacitor will turn off T1. Therefore, the current in the primary winding will flow from B to n and the current in the primary winding will cause the current in the secondary winding to flow counterclockwise.
Advantages of parallel inverters
Several advantages of parallel inverters are as follows:
Stable load voltage: The waveform of the load voltage is independent of the load, and this limitation exists in series inverters. The output voltage of the series inverter depends on the unwanted load.
Cheapest Circuit: The parallel inverter circuit is the cheapest and simplest as it requires only two switches and a center-tapped transformer.
Simple commutation: These inverters use simple Class C commutation operation. Furthermore, the commutation elements do not carry the full load current, which is a very useful aspect of parallel inverters
Few control switches: Compared with H-bridge inverter, only two control switches are needed to complete the operation. The minimum number of switches required for an H-bridge inverter is 4.

Lämna ett svar

Din e-postadress kommer inte att publiceras. behövliga fält är markerade *

Chatta med Kristin
redan 1902 meddelanden

  • kristin 10:12 AM, I dag
    Glad att få ditt meddelande, och detta är kristins svar till dig